The rule of thumb to use a 0.1-µF capacitor on the power pin of a semiconductor device is rapidly fading away. Semiconductor products of today have multiple power pins and voltages. But, it is more ...

Most ICs need to be decoupled from their power supply, usually with a 0.1uF capacitor between each power pin and ground. Decoupling is usually used to remove noise and to smooth power fluctuations.

Decoupling capacitors have long been an important aspect of maintaining a clean power source for integrated circuits, but with noise caused by rising clock frequencies, multiple power domains, and ...

As we have seen in part I and part II of this series [1], there are no inherent wear-out mechanisms in ceramic capacitors. And yes, as covered in part II, the high dielectric Class 2 capacitors (X7R) ...

Noise management, induced by digital circuits on a p. c. board assembly, deserves the attention of power supply designers and those mastering digital, analog, and mixed-mode application problems ...

This white paper discusses a method for driving high-frequency sinusoidal ripple over capacitive loads for power supply rejection ratio (PSRR) testing, an important performance parameter for many ...

AVX has expanded the applications of its LICA series of low inductance decoupling capacitor arrays. Widely utilised in commercial and industrial five nines uptime applications, such as mainframe class ...

Power system designers are constantly under pressure to attain larger power densities and improved conversion efficiencies, whether it is for data servers for the internet of things or data centers.

Everyone knows that the perfect capacitor to decouple the power rails around ICs is a 100 nF ceramic capacitor or equivalent, yet where does this ‘fact’ come from and is it even correct? These are the ...